• This is a classic and stylish product with an elegant appearance; it is powered by its own lithium battery and can be recharged repeatedly
• It is easy to operate and makes bulky work a pleasure, even after long hours of use
• The high-performance copper motor makes waxing and polishing easy and effortless
• The product is easy to operate and lightweight, so even women can easily use it, it is a good partner for your car
• Sanding:
• The sandpaper can be used to remove rust from metal surfaces and painted walls, and to sand wooden surfaces, but please note that the product is equipped with 80 mesh and 320 mesh sandpaper, if the thickness of the sand is not suitable for your use, please go to the hardware shop to buy it yourself, the size of the self-adhesive sheet is 4.5 inches (115cm)
• Waxing:
• Please clean the body first and wipe off any stains or solid particles attached to the surface of the body (if stains or solid particles remain on the body, the waxing will wear the surface of the body)
• Please first confirm that the host battery has been charged, then install the chassis, and sticky waxing cloth pad, the white side is tension velvet sticky on the polishing chassis magic tape, and the orange side of the cotton surface used to contact the car paint seal glaze waxing
• Apply an appropriate amount of wax, usually in a thin layer, to the surface of the cloth or to the surface of the body. Please note that the stain removal wax is used for stain removal; the scratch removal wax is used for abrasive wax; the polishing wax is used for polishing
• Place the product flat on the surface of the bodywork and press the switch to start applying the wax (please do not press the product too hard), it is recommended to use "II" slow speed
• Apply the wax evenly to all parts of the bodywork. The waxing order is generally from high to low: first the roof, then the front of the car, then the rear of the car, and finally the doors (generally apply a thin layer of wax, then slowly extend the wax, if the car wax is applied too much, it will affect the waxing effect)
• After waxing, wait for 3-5 minutes for it to dry, then use a towel to wipe off the excess wax (this step will allow the polishing and varnishing work to be carried out more perfectly)
• Polishing:
• Please first confirm that the host battery has been charged, then install the chassis, stick the polishing cloth pad, white tension fleece that side stick on the polishing chassis magic tape, and white plush that side used to contact the car paint surface for fine polishing
• Before installation, please check whether the polishing velvet cover is dry and ensure that there are no solid particles attached, if there are, please clean up first, otherwise it will damage the car
• Press the operation switch for fine polishing (please do not press the product too hard), it is recommended to use the "I" gear fast gear
• Polishing is over, turn off the power
• Brush to remove dust: for leather goods, sofas or marble, etc. in the crevices of the fine rubbish or dust, can replace the brush disc to use

Specifications:

• Working discharge time: 1-2 hours
• Battery capacity: 2 x 2000mAh
• Power supply: lithium battery included
• Maximum power: 100W
• Disc size: 110cm
• Motor speed: 18000rpm
• Disc speed: 2250rpm
• Product function: sanding, waxing, polishing, brushing dusting