Auto Look Around at Startup: When the car's engine starts, the system will activate the car's monitor and surrounding cameras to check the surrounding field of view for 10 seconds, then turn off
Auto Reverse: When you pull reverse (left/right steering not triggered), the system will activate the display and rear view camera until reverse gear returns, then switch to the front view camera for 10 seconds and then turn off
Front View Mode: The system starts up in front view mode by default. The front view is controlled by a switch (included). Press and hold the control switch for 2 seconds, the on-board monitor and on-board front-view camera will always work if no other triggers are in service. You can then turn off the front view video by pressing the control switch again for 2 seconds
Usage:
Video Output: Two video outputs, one for the car monitor and the other for the car DVR.
Front-view camera power supply: provided by the control box system.
Rearview camera power supply: Powered by the control box system, it can also be powered by the reversing lights.
Left/Right View Camera Power: Provided by the control box system.
Trigger priority:
Right View > Left View > Rear View > Front View
Switch function:
Press for less than 1 second: Side View Mode / Front View Mode
Press and hold for 2 seconds (in front mode): front view / off
Specification:
Current: Maximum: 50mA
Power supply: 9-30V (24V camera for 24V car)
System signal: PAL/NTSC/SECAM
Image sensor: PC1099
Optical Size: 1/3 inch
Pixel pitch: 5.07.4um
Effective Pixels: 720480
Horizontal resolution: 580 TV lines
Dynamic range: >72dB
Signal-to-noise ratio: >48dB
Viewing angle: 170 degrees
Video angle: 1V@75Ω