• 12V voltage, 22MM handlebar inner diameter, suitable for most motorcycle use
• The product is set up with high and low gear switches, you can adjust the handlebar temperature at will (50°C- 70°C adjustable)
• Dual throttle cable clasp, installation range is broader              
• Can be sealed through the mouth design, does not affect the handlebar outside the installation of the handlebar plug, to handlebar light and other decorative accessories, more beautiful and more convenient

Installation Instructions:

• Remove the original handlebar
• The inner hole of the left handlebar is wetted with soapy water, and the twisting amplitude should not be too large during installation
• When installing the balance iron on the left handle, adjust the position of the balance iron to slightly separate from the handle, and do not squeeze the handle when tightening the screws
• If the left handle slides on the steel pipe during use, remove the balancing iron
• Power cord, red wire to positive, black wire to negative, the reverse temperature can not be adjusted
• The left handle should be installed when the power cord should be left enough to rotate the remaining line

Specifications:

• Product Model: CS-095B1
• Product net weight: 248.8g
• Product material: Nitrile rubber
• Input voltage: DC12V
• Product power: 12-24w adjustable
• Product inner diameter: 2.2CM
• Product temperature: the low temperature for 50 ° C, high temperature for 70 ° C
• Handle type: through the mouth electric heating handle
• Switch type: multi-speed adjustable switch
• Applicable models: Handlebar diameter of 22MM 12V motorcycle

Note:

• When installing the left handlebar, do not twist the handlebar too much, too much twisting will cause the electric heating wire displacement
• With balance iron models, please adjust the installation position of the balance iron, do not squeeze the handlebar when tightening the screws, the balance iron, and the handlebar are slightly apart. If the installation position of the balance iron can not be adjusted, please add shims between the balance iron and handle to separate, excessive squeeze handle, will cause handle switch toggle difficulties, electric wire extrusion handle surface, and other abnormal damage