• Made of the best nickel-plated steel, not rust, not easy to bend, not brittle
• Fine workmanship, no burrs, feel good
• Full disk compartmentalized design, not affected by mud and sand and other foreign matter, high leveling
• Used for tiling leveling and positioning to improve flatness and efficiency

Specifications:

• Item No.: DC 1
• Material: nickel-plated steel+ PP
• Weight: 560g

How to Use:

• Pave the first tile, leave a gap, ≥ 2.0 mm or more, needed (with the cross card better), close to the neighboring tiles;
• Insert the T-type steel needle along the tile seam in a word;
• Then, rotate 90 degrees. Snap the T-pin at the bottom of both tiles and turn it left and right to make a little space around;
• Use a hand/adjustment wrench to screw and tighten the adjustment cover clockwise until the two tiles are on the same level;
• About 3-4 hours after leveling, before the cement or tile adhesive is completely dry, reverse the rotation 90 degrees to remove the T-pin.