Anti-fall induction
Gyroscope balance
Controlled by an ic gyroscope to simulate true navigation
The original fixed-point cleaning was just the in-situ cleaning at the center point, but now it is a mosquito-repellent incense route with the center point expanding outward
The function of mopping the floor is added
IC scheme charging, with overcharge and over-discharge short circuit protection
Noise is lower than the original
Edge cleaning, timing, and other functions
The permeable water tank is added to mop the floor
Specification:
Model: RS300
Noise: less than 55 decibels
Suction power: 2800Pa
Dust box: 300ml
Working time: about 90 minutes
Working voltage: 7.4V
Rated power: 15W
USB charging: DC 5V/2A
Size: 32x5x35cm
Current: 1.8A
Battery capacity: 2000mAh
Charging time: about 3 to 4 hours
Cleaning mode: vacuuming, sweeping, mopping, UC ultraviolet
Applicable floor: marble, ceramic tile, wood board, short woolen blanket, etc.
Instructions:
1. Wet it with a special mop and stick it on the bottom of the water tank.
2. After filling the water tank with water, close the lid and dry the outside of the water tank with water droplets.
3. When the machine is paused or turned off, turn the machine upside down, align the water tank with the two screw holes at the end of the machine, and press it tightly.
4. Press the "M" button on the remote control 6 times in turn, and the machine will beep 6 times to switch to the "mopping mode" (other modes are not suitable for using water tanks.)
5. Take out the water tank: After the machine is paused, press the two sides of the water tank with both thumbs, and at the same time use your index fingers to lift the bottom of the machine, and then force the water tank to take out. Do not pull out forcefully with one hand to avoid damaging the water tank.
Note:
1. Please clean the water tank mop in time. If there are foreign objects at the bottom, please clean it up in time to avoid affecting the use.
2. The water tank is made of plastic, please do not drop or knock to avoid damage.